Not covered by this warranty
a)
The warranty policy does not cover any depreciation or damages caused by ordinary
wear, rusting or corrosion, lack of correct maintenance or operation, misuse, abuse, lack
of transportation or accident.
b)
The warranty policy does not cover any costs necessary for the standard periodic
maintenance services instructed by the operator’s manual, or
service parts replacement
which would include oil, filters, tyres, belts, brake linings, fuses, blades, seals and other
service parts unless it can be proven that the item has evidence of faulty manufacture.
c)
The warranty policy will not cover failure or damage caused as a result of parts or
accessories being modified without the written approval of GJ Handy & Co Ltd.
d)
The warranty policy will not cover the unit if non-genuine parts have been fitted and as a
result damage has occurred to the unit.
e)
The warranty policy is non-transferable and is only applicable to the original purchaser.
Disclaimer
a)
This warranty is only a remedy for defect of products. GJ Handy & Co Ltd will never
warranty in terms of the merchantability or the fitness for a particular purpose.
b)
No person is authorised to make any warranties, representations or promises, expressed or
implied, on behalf of GJ Handy & Co Ltd, or to modify the terms conditions or limitation of
this warranty policy in any way.
c)
Neither GJ Handy & Co Ltd nor any company affiliated with GJ Handy & Co Ltd shall be
liable in any event or manner whatsoever for incidental or consequential damages or
injuries, including, but not limited to, loss of crops, loss of profit, out of pocket expenses or
profits, rental of substitute equipment or other commercial losses.
General
a)
Most warrantable failures show up within the first few weeks of use. These failures are
usually straightforward and warranty assessment is relatively easy.
b)
Failures relating to cutter decks and belts need careful investigation, as the cause may
not always be straightforward. Look for damage to blades and pulleys especially when
the cutter belt or blade boss have snapped or cracked as this could be due to impact
damage.
c)
Customers should always refer to the operator/instruction manual when any disputed
problem arises, you will find most areas covered within the manual.
Summary of Contents for QG33-1200
Page 18: ...PARTS DIAGRAM QG33 1200 1938281001...
Page 23: ......
