19
J. Fit the top rear panel (8), resting it on the side panels, and secure it with two screws (9)
K. Apply the rear insulation (10), inserting the edges in the openings at the side and top
L. Fit the rear panel (11) and fasten it with the six screws (12) supplied
M. Insert the top centre panel (13) underneath the top rear panel (8) and rest it on the side
panels
ASSEMBLING THE CASING
A. Remove the outlet and return stubs from the cardboard box inside
the loading/combustion chamber, and install them
B. Fit a screw and nut in the holes on the four bottom brackets (1),
without tightening them
C. Insert them in the top of the four slots provided at the bottom of
the boiler, and secure them with the nuts.
NOTE:
The four top brackets (2) have holes for fastening the paneling to the
tie-rods
D. Fit a bolt and nut in the holes on the four bottom brackets (1),
without tightening them
E. Insert them in the four slots at the bottom of the boiler and tighten
them
F. Insert the four top brackets (2) on the studs and tighten them with
the nuts (3)
G. Apply the insulation (4) around the boiler body
H. Fit the side panels (5), hooking the slots (6) on the bottom of the
panels to the bottom brackets (1)
I. Fasten the panels (6) to the top brackets (2) using the
screws (7) supplied with the casing. Leave the right side loose
after removing the plug in the top of rear section