- 31 -
Clutch
Start engine and increase the winding number slowly to inspect
the actuation of clutch and check the clutch block if the
motorcycle does not move or the engine misses.
Replace the new part if necessary.
Front/rear suspension system
Front
Strain the front brake and compress the front shock absorber
up and down to check the actuation.
Check whether the front shock absorber is leak and each part
is loosen.
Rear
Compress the rear shock absorber up and down to check the
actuation.
Check whether each part of the rear shock absorber is
damaged or loosened.
Suspense the rear wheel and swing it to check whether the
engine suspension bush is loosened.
Nut/bolt/fixture
Check whether the bolt, nut and fixture of the motorcycle is
loosened.
If so, please tighten to specified torque force value.
Compress up
and down
Compress up an
d down
Front heel-axle
Summary of Contents for QJ150T-10
