- 68 -
3.3.2.3 Inspect the front
wheel bearing
Dismantle the front-wheel left spacer
sleeve and take off the oil seal.
Examine the rolling condition of the bearing.
If it doesn’t roll, or the bearing is damaged or loosened, it
should be replaced by new product.
3.3.3 Replace the bearing
After Dismantling the front wheel axle, front wheel as well
as the intermediate axle sleeve and the left axle sleeve of
the front wheel, dismantle the oil seal and bearing by using
the oil seal puller and bearing puller respectively.
Note: the dismantled bearings should be replaced with
new ones.
During the installation, smear grease lubricant on the
bearings.
Then drive in the bearings by bearing installation tools.
* Note
•The bearing must be punched in horizontally.
•The oil seal must be punched outward.
3.3.4 Installation
Smear grease lubricant on the oil seal of the front wheel.
Smear grease lubricant at the joint part and movable parts
of the gear seat components.
Install the intermediate axial sleeve, bearings and oil seal.
Install the front wheel after involving the gear seat
components.
Note
• The gear seat components of the mileage table will be
deformed if these components are not tightly involved.
•Rotate the wheel after mounting the wheel spindle to
confirm whether the driven shaft of speed indicator
rotates.
Install and tighten the front wheel axle.
*Note: the QJ150T-10 forward-mounting assemble and dissemble map can be seen on P65 of this manual.
Torque force
Front wheel-axle clamping nut
55-62 N·m
clearance
clearance
axial direction
radial direction
front wheel rim
Liquid brake pan
rolling bearing
front-wheel left spacer sleeve
Installing bolt of liquid brake pan
front wheel axle
oil seal
intermediate shaft
of front wheell
Summary of Contents for QJ150T-10
