33
Operation Manual of Intelligent High Speed Dome Camera
9.2 Assignment
<< Assignment
Press OPEN or Joystick left/right to enter
Note
：
Users could perform 8 options of assignment to be automatically executed for the dome system,namely to
automatically execute the functions of the dome or the camera at the programmed designated time.
If an executing task is terminated by manual operation, it would be restarted if manual operation is not
performed within 10 seconds after stop.
①
Number
1
<< Number
1
～
8
Joystick left/right to select
Note
：
Assignment priority: 1-8 (High-Low)
②
Program << Program
Press OPEN or Joystick left/right to enter
A)Matter PreShot << Matter PreShot/Vector/Tour/PanScan/DayNight
J
oystick left/right to select
B) Number 1 << Number
Press OPEN or Joystick left/right to enter
Refer to
Number Input Steps Instructions
to set number
Note
：
Number is invalid to PanScan and DayNight optional fucntion, it is used to select certain specific preset
point and the track when PreShot/Vector/Tour is being selected by a specific assignment.
C) Mode Eachday << Mode Eachday
Joystick left/right to select
Eachday/Workday/Weekend/Mon/Tue/Wed/Thurs/Fri/Sat/Sun
D) Start Time Setup << Start time setup
Press OPEN or Joystick left/right to enter
Refer to
Number Input Steps Instructions
to set start time
E)
End Time Setup << End time setup
Press OPEN or Joystick left/right to enter
Refer to
Number Input Steps Instructions
to set end time
Note
：
If the execution time for the assignment from start to end is set less than 3 seconds, this task will
always be executed.
IRIS CLOSE to exit
③
. Enable OFF
<< Enable ON/OFF
Joystick left/right to select
Start Time Setup
1 Hour 0
2 Minute 0
3 Second 0
IRIS CLOSE to exit
End Time Setup
1 Hour 23
2 Minute 59
3 Second 59
IRIS CLOSE to exit
