36
Operation Manual of Intelligent High Speed Dome Camera
Press “ACK” in the end.(Preset point No. + Shot + ACK)
Clear Preset point: Method 1: Firstly input “PRESET”. Then input the number of preset point.
Press “OFF” in the end.( Preset point No. +OFF)
Method 2: Firstly input the preset point no. The press “SHOT”.
Press “OFF” in the end.( Preset point No. + SHOT + OFF)
2.
Users Logon Operation
Please invoke No.92 preset position for administrator’s logon.
Please invoke No.93 preset position for the logon of operator.
Factory Password
: Administrator: 000000 Operator: 111111
Attention: Administrator password must be properly kept. While the dome shall be returned to the factory if it is
lost.
3. OSD Menu of Speed Dome: 90+PRE Enter the OSD Menu of Speed Dome
4. OSD Menu of Camera: 57+PRE Enter the OSD Menu of Camera
5.Description of “cruise track” function:
a)
When enter “
51+Enter
”, the device is enabled system default cruise track. The device will auto scan
point by point from No.1 preset position to No.16 preset position. If certain position has not been preset or been
cleared after preset, “
cruise track
” will not scan them.
b)
Dwell time of the preset position is 2 seconds.
c)
About other 6 cruise tracks operation, please refer operation manual of the keyboard controller.
Different controller
is with different operation.
6. Description of “Line-Scanning” function:
a)
Dome device will auto line-scan between two specified points.
b)
User can set the start point by “52+Enter” and end point by “53+Enter”.
c)
Line scanning speed set: user keep a manual line scan speed three seconds above, then through “CALL+51
+Enter” to save the speed as line scan speed, use“CALL+52+Enter” to enable the line scan.
d)
Dwell time of line-scanning between “starting point” and “ending point” is 2 seconds.
7. Intelligent manually pan continuous scan:
When user use joystick for pan scan monitoring, keep manually 3 seconds, then press “CALL+101+Enter”, the
dome can go on with the scan speed and monitor position automatically .
