Chapter 6 Robot Operation
Document Version V1.1.0(01/11/2023) 87
Solution to connection failure:
Step 1
Rescan the robot's IP address; If the IP address of the
robot can be scanned, try to reconnect to the robot; If
the IP address of the robot cannot be scanned, check
whether the network cable between the host
computer and the robot is connected normally, or
whether the network port connected to the robot is
correct, and the network port connected to the robot
by the network cable is a LAN port.
Step 2
If the robot can be scanned in Step 1 but the
connection fails, check whether the IP addresses of
the host computer and the robot are in the same
network segment. Make sure that the IP addresses of
the host computer and the robot are in the same
network segment.
Step 3
Execute system search and run cmd as shown in the
figure:
