Quick Guide PROFI II
2. Bleeding
2.1
Open the
bleeding tap (Fig. 1)
2.2
Switch on with the key
(
off
⇒
green
green
) and wait until water comes evenly from the vent hose under the machine
2.3
Switch on with the key
(
green
green
⇒
off
)
2.4
Place the
suction hose for the cleaning solution (Fig. 1)
into the cleaning solution tank
2.5
Set the
dosing pump regulator (Fig. 2)
to 100%
2.6
Switch on with the key
(
off
⇒
green
green
/
turquoise
turquoise
) and wait until the key
lights up
green
green
continuously
2.7
Switch off with the key
(
green
green
⇒
off
)
2.8
Attach the hose to the rod and brush bow or ROTAQLEEN, connect cable for the ROTAQLEEN to the
ROTAQLEEN socket (Fig. 1)
and the ROTAQLEEN.
2.9
The machine is ready for operation
3. Cleaning with pure water
3.1
Switch on the machine with the key
(
off
⇒
green
green
)
3.2
After a short time, the clean water arrives at the nozzles via the blue hose
4. Cleaning with cleaning solution
4.1
Switch on the machine with the key
(
off
⇒
green
green
), if the key
should light up
turquoise
turquoise
the
dosing pump controller (Fig. 2)
is set to 0 % and must be turned up
(
turquoise
turquoise
⇒
green
green
)
4.2
After a short time, the cleaning agent solution arrives at the nozzles via the black hose
Control buttons and dosing pump regulator
ROTAQLEEN
direction
Dosiung pump regulator
2
Power switch
Pure/
line water
Cleaning solution/
line water
1. Connection water and power
1.1
The
water input (Fig. 1)
can be connected as follows:
• With the Gardena adapter via a Gardena hose to the house water connection and
• Then open the water inlet of the house water connection
• Remove the Gardena adapter and connect the suction hose to the machine and sink the side with the
filter into the water tank
1.2
Connect the
mains plug (Fig. 1)
supply to the power socket
1.3
Unroll the hose to the required length and connect the
connection for the black hose (Fig. 1)
to the reel
1.4
Switch on the machine with
button lights
green
green
for battery operation and
turquoise
turquoise
for mains operation.
1.5
If the
battery indicator (Fig. 5)
shows
red
red
and the machine does not start, the battery must be charged,
see Chapter
9. Charging the battery
Connections
Connection for
the black hose
ROTAQLEEN socket
1
Mains plug
Water flow regulator
black hose
Bleeding tap
Suction hose for
cleaning solution
Water input
