3.
Press the
-button
B
to turn the heater into low power mode. The displays shows
. The
heater will continue operating in low power mode until the power is switched off manually
or if the room temperature exceeds 30ºC.
4.
Press the
-button
B
once again to switch the heater off.
TEMPERATURE SETTING
1.
Press the
Mode
button until the temperature icon
blinks. The set temperature is
displayed and can be changed as the temperature icon
is blinking.
2.
Use the + and - button to set the desired temperature, from 13 to 30ºC.
3.
The temperature icon
will stop blinking and the current room temperature will appear
after the desired temperature is set.
4.
Once the room temperature exceeds the set temperature for over 10 seconds, the heater
will stop heating and the temperature icon
will blink.
5.
Once the room temperature drops 1ºC below the set temperature, the heater will start
heating again and the temperature icon on the display will stop blinking.
OVERHEAT PROTECTION
This appliance has two levels of overheat protection:
1.
Automatic thermal cut-off
Switches off the heater in the event of overheating or malfunction and resets once the
temperature drops to a normal level
2. Thermal fuse
In the event that the automatic thermal cut-off fails to operate, the heater has a further
safety device. This is a non-resettable switch which will require the unit be returned to an
approved service centre for replacement.
If overheating or malfunctions occur on a regular basis, return the heater to an approved service
centre for examination.
TIMER SETTING
AUTO OFF
Make sure to set the desired temperature prior to setting the timer, so that the heater
will shut off at the desired temperature setting.
With the Auto OFF timer setting you can decide the time that the heater should automatically
switch of.
1.
Keep pressing the Mode button until the timer icon blinks. The Auto Off icon will also
appear.
2.
Use the + and - buttons to set the heater operation time between 1 and 24 hours
(default is 10 hours).
3.
The heater will automatically turn off when the set timer setting runs out.
POWER
4
28
Summary of Contents for EOR 1515 LCD
Page 31: ...31 4 31...
