8–Using QLogic Control Suite
Configuring Teaming
135
83840-546-00 D
The Large Send Offload (LSO) and Checksum Offload (CO) columns
indicate if the LSO, Jumbo MTU, and/or the CO properties are supported for
the adapter. The LSO, Jumbo MTU, and CO properties are enabled for a
team only when all of the members support and are configured for the
feature. If this is the case, then the team offload capabilities appear on the
bottom of the screen.
Figure 8-14. Adding an Adapter to a Team
8.
If you want to designate one of the adapters as a standby member
(optional), select
Use the following member as a standby member
, then
choose the standby member from the list of adapters.
NOTE
If an adapter is included as a member of a team and you change
any advanced property, then you must rebuild the team to ensure
that the team’s advanced properties are properly set.
Adding a network adapter to a team where its driver is disabled
may negatively affect the offloading capabilities of the team. This
may have an impact on the team’s performance. Therefore, it is
recommended that only driver-enabled network adapters be added
as members to a team.
Summary of Contents for 8400 Series
Page 390: ......
