8–Using QLogic Control Suite
Configuring With the Command Line Interface Utility
152
83840-546-00 D
Viewing ASP Statistics
The Statistics section shows performance information about the network adapters
that are on a team.
To view ASP Statistics information for any team member adapter or the team as a
whole, click the name of the adapter or team listed in the Team Management
pane, then click the
Statistics
tab.
Click
Refresh
to get the most recent values for each statistic. Click
Reset
to
change all values to zero.
Configuring With the Command Line Interface
Utility
An alternate method to QCS for configuring QLogic network adapters is with QCS
CLI, which is a QLogic utility that allows you to view information and configure
network adapters using a console in either a non-interactive command line
interface (CLI) mode or an interactive mode. As with QCS, QCS CLI provides
information about each network adapter, and enables you to perform detailed
tests, run diagnostics, view statistics, and modify property values. QCS CLI also
allows you the ability to team network adapters together for load balancing and
failover.
For a complete list of available commands and examples, see the QCS CLI
ReadMe text file on the CD.
QCS CLI is installed when QCS is installed with the installer.
Troubleshooting QCS
Problem
: When attempting to open QCS on a Linux System, the following error
message appears:
Another instance of the QCS client appears to be running on this
system. Only one instance of the QCS client can be running at a
time. If you are sure that no other QCS client is running, then a
previous instance may have quit unexpectedly.
Solution
: This message displays if you try to run a second instance of QCS. If you
receive this message but are certain that no instance of QCS is currently running,
a previous instance of QCS may have quit unexpectedly. To clear that instance,
remove the file
/dev/shm/sem.Global-BACS-{C50398EE-84A7-4bc3-9F6E-25A69603B9C0}
Summary of Contents for 8400 Series
Page 390: ......
