10–iSCSI Protocol
iSCSI Boot
170
83840-546-00 D
To configure the iSCSI boot parameters using static configuration:
1.
In the Main menu, select
iSCSI Boot Configuration
), and then
press ENTER.
Figure 10-5. Selecting iSCSI Boot Configuration
2.
In the iSCSI Boot Main menu, select
General Parameters
(
and then press ENTER.
Figure 10-6. Selecting General Parameters
1.
In the General Parameters
menu, use the up or down arrow keys to select a
parameter, and then use the right or left arrow keys to set the following
values.
TCP/IP Parameters via DHCP
: Disabled (IPv4)
IP Autoconfiguration
: Disabled (IPv6)
iSCSI Parameters via DHCP
: Disabled
CHAP Authentication
: As required
Boot to iSCSI Target
: As required
DHCP Vendor ID
: As required
Link Up Delay Time
: As required
Use TCP Timestamp
: As required
Target as First HDD
: As required
LUN Busy Retry Count
: As required
Summary of Contents for 8400 Series
Page 390: ......
