10–iSCSI Protocol
iSCSI Boot
171
83840-546-00 D
IP Version: As Required
(IPv6, non-offload)
HBA Boot Mode
: As required
1
2.
Press ESC to return to the iSCSI Boot Main menu. Select
Initiator
Parameters
, and then press ENTER.
3.
In the Initiator Parameters menu, select the following parameters, and then
type a value for each:
IP Address
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS
iSCSI Name
(corresponds to the iSCSI initiator name to be used by
the client system)
CHAP ID
CHAP Secret
4.
Press ESC to return to the iSCSI Boot Main
menu. Select
1st Target
Parameters
, and then press ENTER.
1
HBA Boot Mode cannot be changed when the adapter is in Multi-Function mode.
NOTE
For initial OS installation to a blank iSCSI target LUN from a CD/DVD-ROM
or mounted bootable OS installation image, set
Boot to iSCSI Target
to
One Time Disabled
. This causes the system not to boot from the configured
iSCSI target after establishing a successful login and connection. This
setting will revert to
Enabled
after the next system reboot.
Enabled
means
to connect to an iSCSI target and attempt to boot from it.
Disabled
means to
connect to an iSCSI target and not boot from that device, but instead hand
off the boot vector to the next bootable device in the boot sequence.
NOTE
Carefully enter the IP address. There is no error-checking performed against
the IP address to check for duplicates or incorrect segment/network
assignment.
Summary of Contents for 8400 Series
Page 390: ......
