17–QLogic Teaming Services
Event Log Messages
323
83840-546-00 D
Event Log Messages
Windows System Event Log Messages
Base Driver (Physical Adapter/Miniport)
Intermediate Driver (Virtual Adapter/Team)
Windows System Event Log Messages
The known base and intermediate Windows System Event Log status messages
for the QLogic 8400/3400 Series adapters are listed in
.
As a QLogic adapter driver loads, Windows places a status code in the system
event viewer. There may be up to two classes of entries for these event codes
depending on whether both drivers are loaded (one set for the base or miniport
driver and one set for the intermediate or teaming driver).
Base Driver (Physical Adapter/Miniport)
The base driver is identified by source
L2ND
lists the event log
messages supported by the base driver, explains the cause for the message, and
provides the recommended action.
NOTE
In
, message numbers 1 through 17 apply to both NDIS 5.x and
NDIS 6.x drivers, message numbers 18 through 23 apply only to the NDIS
6.x driver.
Table 17-8. Base Driver Event Log Messages
Message
Number
Severity
Message
Cause
Corrective Action
1
Error
Failed to allocate
memory for the
device block. Check
system memory
resource usage.
The driver cannot allo-
cate memory from the
operating system.
Close running applica-
tions to free memory.
2
Error
Failed to allocate
map registers.
The driver cannot allo-
cate map registers from
the operating system.
Unload other drivers
that may allocate map
registers.
Summary of Contents for 8400 Series
Page 390: ......
