17–QLogic Teaming Services
Event Log Messages
325
83840-546-00 D
11
Informational
Network controller
configured for 1Gb
full-duplex link.
The adapter has been
manually configured for
the selected line speed
and duplex settings.
No action is required.
12
Informational
Network controller
configured for 2.5Gb
full-duplex link.
The adapter has been
manually configured for
the selected line speed
and duplex settings.
No action is required.
13
Error
Medium not sup-
ported.
The operating system
does not support the
IEEE 802.3 medium.
Reboot the operating
system, run a virus
check, run a disk check
(chkdsk), and reinstall
the operating system.
14
Error
Unable to register
the interrupt service
routine.
The device driver can-
not install the interrupt
handler.
Reboot the operating
system; remove other
device drivers that may
be sharing the same
IRQ.
15
Error
Unable to map IO
space.
The device driver can-
not allocate mem-
ory-mapped I/O to
access driver registers.
Remove other adapt-
ers from the system,
reduce the amount of
physical memory
installed, and replace
the adapter.
16
Informational
Driver initialized suc-
cessfully.
The driver has suc-
cessfully loaded.
No action is required.
17
Informational
NDIS is resetting the
miniport driver.
The NDIS layer has
detected a problem
sending/receiving pack-
ets and is resetting the
driver to resolve the
problem.
Run QLogic Control
Suite diagnostics;
check that the network
cable is good.
18
Error
Unknown PHY
detected. Using a
default PHY initial-
ization routine.
The driver could not
read the PHY ID.
Replace the adapter.
Table 17-8. Base Driver Event Log Messages (Continued)
Message
Number
Severity
Message
Cause
Corrective Action
Summary of Contents for 8400 Series
Page 390: ......
