10–iSCSI Protocol
iSCSI Boot
165
83840-546-00 D
iSCSI Boot Setup
The iSCSI boot setup consists of:
Configuring iSCSI Boot Parameters
Preparing the iSCSI Boot Image
Configuring the iSCSI Target
Configuring the iSCSI target varies by target vendors. For information on
configuring the iSCSI target, refer to the documentation provided by the vendor.
The general steps include:
1.
Create an iSCSI target (for targets such as SANBlaze
®
or IET
®
) or a
vdisk/volume (for targets such as EqualLogic
®
or EMC
®
).
2.
Create a virtual disk.
3.
Map the virtual disk to the iSCSI target created in step 1.
4.
Associate an iSCSI initiator with the iSCSI target.
5.
Record the iSCSI target name, TCP port number, iSCSI Logical Unit
Number (LUN), initiator Internet Qualified Name (IQN), and CHAP
authentication details.
6.
After configuring the iSCSI target, obtain the following:
Target IQN
Target IP address
Target TCP port number
Target LUN
Initiator IQN
CHAP ID and secret
Configuring iSCSI Boot Parameters
Configure the QLogic iSCSI boot software for either static or dynamic
configuration. Refer to
for configuration options available from the
General Parameters screen.
Summary of Contents for 8400 Series
Page 390: ......
