4-VMM2008 R2 Setup, VM Creation, and NPIV SAN Migration
VM Creation
4-6
5.
Click
Next
until the Select Destination dialog box opens.
Ensure that the
Place Virtual Machine on host
button is selected (see
Figure 4-5
).
Figure 4-5. Select Destination
6.
Click
Next
.
The Select Virtual Machine Host dialogue box opens. Verify that the
Transfer type column has a SAN entry for the host you want to select.
Check the
SAN Explanation
tab to ensure that there are no warnings other
than for iSCSI. In this example, HostServerA is selected.
Summary of Contents for Fibre Channel NPIV Storage Networking Guide
