4–Configuration
Controlling per-Host LUN Access on the iSR6200
4-26
ISR651101-00 G
4.
In the Security Check dialog box, type the system password (the default is
config
), and then click
Next
.
The LUN Masking Configuration Status window lists the mapping requests,
as shown in
.
Figure 4-22. Target Presentation/LUN Mapping Wizard—LUN Masking
Configuration Status
5.
Verify the completion status shown on the LUN Masking Configuration
Status window, and then click
Finish
to close the wizard.
You can map additional LUNs using either SANsurfer Router Manager or the CLI.
The iSCSI host cannot access mapped LUNs until it logs into the presented target
for the corresponding iSR6200 virtual port group and Fibre Channel target
WWPN.
uses color coding to identify the LUN mapping that became available
after the host logs into the presented targets.
Summary of Contents for iSR6200
