2–Planning
High Availability
ISR651101-00 G
2-7
High Availability
A dual-blade iSR6200 router supports high availability, which provides link-level,
switch-level, and blade-level failure protection. To make this effective, you must
connect the iSCSI hosts to both iSR6200 blades. For details, see
iSCSI Hosts to the iSR6200” on page 4-16
.
Management
SANsurfer Router Manager and the CLI run on a management workstation used
to configure, control, and maintain the router. Support platforms include Windows,
Solaris, and Linux. The SANsurfer Router Manager utility is installed and
executed on the workstation.
The router supports the following management interfaces:
SANsurfer Router Manager
is a graphical user interface (GUI) utility that
runs on a management workstation (see the
iSR6200 Router Manager
User’s Guide
).
CLI
is the command line interface that runs on the router; users can access
the CLI by means of Telnet or the serial port (see the
iSR6200 CLI User’s
Guide
).
SNMP
provides router status, traps, and alerts (for details, see
Recovery
You should have a process in place to recover from a possible router failure.
Consider the following when developing a recovery process for the router:
Save all firmware image files (updates) in a safe, well-known place, because
you may:
Want to revert to a previous firmware version
Need the firmware image when replacing a single-blade router
Need the firmware image when adding a router to your site
Save the router’s configuration (as a new file) after every configuration
change, because you may:
Want to revert to a previous configuration
Need to configure a replacement blade in a single-blade router
Save the router’s LUN mappings (as a new file) after every mapping
change, because you may:
Want to revert to a previous LUN mapping
Need to LUN-map a replacement blade in a single-blade router
Summary of Contents for iSR6200
