4–Configuration
Zoning Virtual Port Groups on the SAN
4-10
ISR651101-00 G
When connecting a single-bladed iSR6200 to two independent SANs, connect
one Fibre Channel port from your iSR6200 blade to each SAN (see
This topology ensures Fibre Channel link-level and switch-level failure protection.
Figure 4-6. Single Blade, Dual Fibre Channel Switch
iSR6200
FC Target Array
SAN B
Blade 1
21:00:00:c0:dd:13:16:f8
21:01:00:c0:dd:13:16:f8
21:02:00:c0:dd:13:16:f8
FC1
FC2
21:00:00:c0:dd:13:16:f9
21:01:00:c0:dd:13:16:f9
21:02:00:c0:dd:13:16:f9
FC1
A0
A1
B0
B1
Controller A
Controller B
FC2
FC1
FC2
6200 FC_One A
SAN A
A0
B1
21:00:00:c0:dd:13:16:f8
21:01:00:c0:dd:13:16:f8
21:02:00:c0:dd:13:16:f8
6200 FC_Two B
A1
B0
21:00:00:c0:dd:13:16:f9
21:01:00:c0:dd:13:16:f9
21:02:00:c0:dd:13:16:f9
Summary of Contents for iSR6200
