6–iSCSI Noninteractive Commands
-ipdhcp (Configure IP Settings)
SN0054667-00 C
6-13
Where:
-ipdhcp
(Configure IP Settings)
To set the adapter to get its IP address, subnet mask, and gateway from the
DHCP server, issue the
-ipdhcp
command as follows:
-ipdhcp <
hba_port_inst>
[-
option
]
If the adapter port had prior values set manually, the DHCP values replace them.
Where
[
option
]
includes:
<hba_port_inst>
= The specific adapter to which the data is written
<
hba_port_inst_
source
>
= The file with the adapter configuration you want.
A
= Configure all imported parameters (F, N, I, T, C, B).
F
= Configure the firmware.
N
= Configure the network parameters.
I
= Configure the iSCSI name.
T
= Configure the targets.
C
= Configure the CHAP table.
B
= Configure the boot parameters (only valid when the
T
[targets] parameter is also specified).
file_name
= The XML file with the adapter configuration. See
Host Configuration)” on page 6-23
-DISN4
= Disable IPv4 network
-IPV4DHCP
= Set DHCP ON
-IP
= Set IP Address
-IPNM
= Set IP Netmask
-IPGW
= Set IP Gateway
-DISN6
= Disable IPv6 network setup
-IPLLA
= Set local link address automatically
-IPLL
= Set local link address manually
-IPRA
= Set IPR0 and IPR1 automatically
-IPR0
= Set routable address 0 manually
-IPR1
= Set routable address 1 manually
-IPRAA
= Set router address automatically
-IPRR
= Set router address manually
Summary of Contents for QConvergeConsole CLI 2400 Series
