2 – QLE2360/2362
Installation in the Computer
2-2
PX2454601-00 C
Q
2.1.1
LEDs
Figure 2-2
identifies and describes the activity of the QLE2360/2362 HBA LEDs.
The red LED on the bracket is not used. For more information about the beacon
LED activity, see the
SANsurfer FC HBA Managers User’s Guide
(FS0054601-00).
Figure 2-2. QLE2360/2362 HBA LED Activity
2.2
Installation in the Computer
Before you install the QLE2360/2362 HBA in your computer, you need the following:
■
A screwdriver (usually a Phillips #1)
■
One (QLE2360) or two (QLE2362) optical multimode cables with LC-style duplex
connectors
CAUTION!
The QLE2360/2362 HBA contains parts that can be damaged by ESD.
Before handling the QLE2360/2362 HBA, use standard methods to
discharge static electricity. Keep the QLE2360/2362 HBA in the
antistatic bag until you are ready to install it. Place the HBA on the bag
when you examine or configure it. Retain the bag for future use.
Activity
Green LED
Amber LED
Red LED
Power Off
Off
Off
Off
Power On (Before
Firmware Init)
On
Off
Off
Online, 1Gb/s link
established
One flash
every 4 Sec.
Off
Off
1Gb/s activity
One flash
every 4 Sec.
On
Off
Online, 2Gb/s link
established
Two flash
every 4 Sec.
Off
Off
2Gb/s activity
Two flash
every 4 Sec.
On
Off
Power On (After
Firmware Init
and/or Loss of
Sync)
On
Off
On
Firmware Error
Error Code
Error Code
On
Beacon
Flash
Flash
Flash
GREEN LED
AMBER LED
J1 CONNECTOR
J2 CONNECTOR
J1 CONNECTOR LEDs
J2 CONNECTOR LEDs
GREEN LED
AMBER LED
RED LED
RED LED
