P
reli
mi
na
ry
set <command type>
SANbox-8/16 Switch Management
User’s Manual
59010-06 Rev. A
Telnet
3-7
The default is 2560 and should not be changed without consulting
QLogic Customer Support or your authorized service provider.
loop nl-port <enable | bypass > <nl_port_addr>
Enable or Disable (put into bypass mode) an NL-Port on an arbitrated loop.
loop status <port_num> <enable | disable>
Enable or Disable arbitrated loop on a port. This can be done with the above
command, or through the ’set config’ command.
memory <address> <value> [byte | word | long]
Writes memory location <address> with value <value>. The entered value must
match the default entry length parameter, or the specified length parameter.
<Address>
is from zero to FFFFFFFF
16
<Value>
is dependent on the [byte | word | long] parameter
For byte sets, value is from 00
16
to FF
16
For word sets, value is from 00
16
to FFFF
16
For long sets, value is from 00
16
to FFFFFFFF
16
If the length parameter [byte | word | long] is not specified, the default is byte.
Chassis ID
: 00100000
Worldwide Name
: 100000C0 DD004175
Sys Config Reg
: 400000
Mac Address
: 00C0DD004174
Reserved :
0000
Long HW Version
: 73000a
network
The command returns a display similar to the following:
[1] - Network IP Address
[2] - Network Mask
[3] - Broadcast IP Address
[4] - Gateway IP Address
[5] - Enable Bootp
[6] - ARP Timeout
[<enter>] - To exit this menu, press the enter key
Please enter the configuration parameter to set:
Selecting items 1 through 4 require entering an IP address in the xxx.xxx.xxx.xxx
format. Selecting item 5 requires selecting to enable or disable the use of a Bootp
server. If selected, and no Bootp server responds during switch startup, the switch
will use the saved value. If item 6 is selected, the ARP timeout value must be
entered (in milliseconds).
Summary of Contents for SANbox-16
