14 – Command Reference
Show Log
59183-02 A
14-129
A
options
Displays the options that are available for configuring event logging and automatic
display to the screen. Refer to the
“Set Log” command on page 14-86
for
information about how to configure event logging and display level.
port
Displays the ports being monitored for events. If an event occurs which is of the
defined level and on a defined component, but not on a defined port, no entry is
made in the log.
settings
Displays the current filter settings for component, severity level, port, and display
level. This command is equivalent to executing the following commands
separately: Show Log Component, Show Log Level, and Show Log Port.
Examples
The following is an example of the Show Log Component command:
SANbox #> show log component
Current settings for log
------------------------
FilterComponent NameServer MgmtServer Zoning Switch Blade Port Eport Snmp
The following is an example of the Show Log Level command:
SANbox #> show log level
Current settings for log
------------------------
FilterLevel Info
DisplayLevel Critical
The following is an example of the Show Log Options command:
SANbox #> show log options
Allowed options for log
-----------------------
FilterComponent All,None,NameServer,MgmtServer,Zoning,Switch,Blade,Port,Eport,Snmp,CLI,Qfs
FilterLevel Critical,Warn,Info,None
DisplayLevel Critical,Warn,Info,None
Summary of Contents for SANbox 5000 Series
