A – Command Line Interface
Set Config Command
A-68
59056-03 C
A
zoning
Initiates an editing session in which to change switch zoning attributes. The
system displays each parameter one line at a time and prompts you for a value.
For each parameter, enter a new value or press the Enter key to accept the
current value shown in brackets.
Table A-22. Set Config Zoning Parameters
Parameter
Description
InteropAutoSave
Available only when the InteropMode parameter is Standard,
this parameter enables (True) or disables (False) the saving of
changes to active zone set in the switch’s permanent memory.
Refer to
”InteropMode” on page A-66
. The default is True.
Disabling the Autosave parameter can be useful to prevent
the propagation of zoning information when experimenting
with different zoning schemes. However, leaving the Autosave
parameter disabled can disrupt device configurations should a
switch have to be reset. For this reason, the Autosave
parameter should be enabled in a production environment.
DefaultVisibility
Enables (All) or disables (None) communication among the
switch’s ports/devices and the fabric in the absence of an
active zone set. The default is All.
DiscardInactive
Enables (True) or disables (False) the discarding of all
inactive zone sets from that zoning database. Inactive zone
sets are all zone sets except the active zone set. The default
is False.
Summary of Contents for SANbox 5200 Series
Page 48: ...2 Using SANsurfer Switch Manager Using the Faceplate Display 2 30 59056 03 C A Notes...
Page 152: ...4 Managing Switches Displaying Hardware Status 4 46 59056 03 C A Notes...
Page 180: ...5 Managing Ports Graphing Port Performance 5 28 59056 03 C A...
Page 318: ...A Command Line Interface Zoning Command A 138 59056 03 C A Notes...