A – Command Line Interface
Set Setup Command
A-80
59056-03 C
A
Set Setup Command
Manages configuration settings for Remote Authentication Dial-In User Service
(RADIUS) servers, switch services, SNMP, and system configurations.
Authority
Admin session
Syntax
set setup
radius
services
snmp
system
Keywords
radius
Prompts you in a line-by-line fashion to configure RADIUS servers for user
account and device authentication.
Table A-23
describes the RADIUS server
configuration fields.
Table A-23. RADIUS Service Settings
Entry
Description
DeviceAuthOrder
Authenticator priority for devices:
Local: Authenticate devices using only the local
security database. This is the default.
Radius: Authenticate devices using only the security
database on the RADIUS server.
RadiusLocal: Authenticate devices using the RADIUS
server security database first. If the RADIUS server is
unavailable, then use the local switch security
database.
UserAuthOrder
Authenticator priority for user accounts:
Local: Authenticate users using only the local security
database. This is the default.
Radius: Authenticate users using only the security
database on the RADIUS server.
RadiusLocal: Authenticate users using the RADIUS
server security database first. If the RADIUS server is
unavailable, then use the local switch security
database.
TotalServers
Number of RADIUS servers to configure during this
session. Setting TotalServers to 0 disables all RADIUS
authentication. The default is 0.
ServerIPAddress
IP address of the RADIUS server. The default is 10.0.0.1.
ServerUDPPort
User Datagram Protocol (UDP) port number on the
RADIUS server. The default is 1812.
Summary of Contents for SANbox 5200 Series
Page 48: ...2 Using SANsurfer Switch Manager Using the Faceplate Display 2 30 59056 03 C A Notes...
Page 152: ...4 Managing Switches Displaying Hardware Status 4 46 59056 03 C A Notes...
Page 180: ...5 Managing Ports Graphing Port Performance 5 28 59056 03 C A...
Page 318: ...A Command Line Interface Zoning Command A 138 59056 03 C A Notes...