![background image](http://html2.mh-extra.com/html/qlogic/sanbox-5200-series/sanbox-5200-series_user-manual_3279626264.webp)
A – Command Line Interface
Set Setup Command
A-84
59056-03 C
A
snmp
Prompts you in a line-by-line fashion to change SNMP configuration settings.
Table A-25
describes the SNMP fields. For each parameter, enter a new value or
press the Enter key to accept the current value shown in brackets.
Table A-25. SNMP Configuration Settings
Entry
Description
SNMPEnabled
Enables (True) or disables (False) SNMP on the switch. The
default is True.
Contact
Specifies the name of the person to be contacted to respond
to trap events. The name can be up to 64 characters
excluding #, semicolon (;), and comma (,). The default is
undefined.
Location
Specifies the name of the switch location. The name can be
up to 64 characters excluding #, semicolon (;), and comma
(,). The default is undefined.
Trap [1-5] Address
Specifies the workstation IP address to which SNMP traps
are sent. The default address for trap 1 is 10.0.0.254. The
default address for traps 2–5 is 0.0.0.0. Addresses, other
than 0.0.0.0, for all traps must be unique.
Trap [1-5] Port
Specifies the workstation port to which SNMP traps are sent.
Valid workstation port numbers are 1–65535. The default is
162.
Trap [1-5] Severity
Specifies the severity level to use when monitoring trap
events. The default is Warning.
Trap [1-5] Version
Specifies the SNMP version (1 or 2) to use in formatting
traps. The default is 2.
Trap [1-5] Enabled
Specifies whether traps (event information) are enabled or
disabled (default).
ReadCommunity
Read community password that authorizes an SNMP agent
to read information from the switch. This is a write-only field.
The value on the switch and the SNMP management server
must be the same. The read community password can be up
to 32 characters excluding #, semicolon (;), and comma (,).
The default is “public”.
WriteCommunity
Write community password that authorizes an SNMP agent
to write information to the switch. This is a write-only field.
The value on the switch and the SNMP management server
must be the same. The write community password can be
up to 32 characters excluding #, semicolon (;), and comma
(,). The default is “private”.
Summary of Contents for SANbox 5200 Series
Page 48: ...2 Using SANsurfer Switch Manager Using the Faceplate Display 2 30 59056 03 C A Notes...
Page 152: ...4 Managing Switches Displaying Hardware Status 4 46 59056 03 C A Notes...
Page 180: ...5 Managing Ports Graphing Port Performance 5 28 59056 03 C A...
Page 318: ...A Command Line Interface Zoning Command A 138 59056 03 C A Notes...