A – Command Line Interface
Set Setup Command
59056-03 C
A-85
A
system
Prompts you in a line-by-line fashion to change system configuration settings.
Table A-26
describes the system configuration fields. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
TrapCommunity
Trap community password that authorizes an SNMP agent
to receive traps. This is a write-only field. The value on the
switch and the SNMP management server must be the
same. The trap community password can be up to 32
characters excluding #, semicolon (;), and comma (,). The
default is “public”.
AuthFailureTrap
Enables (True) or disables (False) the generation of traps in
response to trap authentication failures. The default is False.
ProxyEnabled
Enables (True) or disables (False) SNMP communication
with other switches in the fabric. The default is True.
NOTE:
Changing the IP address will terminate all Ethernet management
sessions.
Table A-26. System Configuration Settings
Entry
Description
Eth0NetworkDiscovery
Ethernet boot method: 1 - Static, 2 - Bootp, 3 - DHCP,
4 - RARP. The default is 1 - Static.
Eth0NetworkAddress
Ethernet Internet Protocol (IP) address. The default is
10.0.0.1.
Eth0NetworkMask
Ethernet subnet mask address.
Eth0GatewayAddress
Ethernet IP address gateway.
AdminTimeout
Amount of time in minutes the switch waits before
terminating an idle Admin session. Zero (0) disables
the time out threshold. The default is 30, the maximum
is 1440.
InactivityTimeout
Amount of time in minutes the switch waits before
terminating an idle Telnet command line interface
session. Zero (0) disables the time out threshold. The
default is 0, the maximum is 1440.
Table A-25. SNMP Configuration Settings (Continued)
Entry
Description
Summary of Contents for SANbox 5200 Series
Page 48: ...2 Using SANsurfer Switch Manager Using the Faceplate Display 2 30 59056 03 C A Notes...
Page 152: ...4 Managing Switches Displaying Hardware Status 4 46 59056 03 C A Notes...
Page 180: ...5 Managing Ports Graphing Port Performance 5 28 59056 03 C A...
Page 318: ...A Command Line Interface Zoning Command A 138 59056 03 C A Notes...