2–Managing Fabrics
Zoning
59264-02 B
2-31
Editing the Zoning Database
Use the Edit Zoning dialog box (
) to edit the zoning database for a
particular switch. To view the Edit Zoning dialog box, on the
Zoning
menu, click
Edit Zoning
. Changes can only be made to inactive zone sets, which are stored
in flash (non volatile) memory and retained after resetting a switch.
Figure 2-12. Edit Zoning Dialog Box
To apply zoning to a fabric, choose a zone set and activate it. When you activate a
zone set, the switch distributes that zone set and its zones, excluding aliases, to
every switch in the fabric. This zone set is known as the active zone set.
You cannot edit an active zone set on a switch. You must configure an inactive
zone set to your needs and then activate that updated zone set to apply the
changes to the fabric. When you activate a zone set, the switch distributes that
zone set to the temporary zoning database on every switch in the fabric. However,
in addition to the merged active zone set, each switch maintains its own original
zone set in its zoning database. Only one zone set can be active at one time.
Port/Device
Tree
Zone Sets
Tree
