P
reli
mi
na
ry
Editing the Configuration File (config)
SANbox-8/16 Switch Management
User’s Manual
59010-06 Rev. A
TFTP
4-5
Editing the Configuration File (
config
)
The config file must be edited using an ASCII editor. On the Windows platform,
this can be a program such as Notepad or Wordpad. On the Unix platform, this can
be a program such as VI. After making all desired changes, save the file on the
management station hard drive, overwriting the existing file.
T
he Switch Management Configuration File
The parameters of the Switch management configuration file (config) are:
•
netAddress The IP network address. By default this is 10.0.0.1.
•
netMask The IP subnetwork mask. By default this is 255.0.0.0.
•
broadcast The IP broadcast address. By default this is 10.255.255.255. If
this parameter is omitted from the configuration, the Switch will compute the
correct broadcast address from netAddress and netMask.
•
gateway The IP address of the network gateway. If this parameter is set to
0.0.0.0, the Switch will assume that no gateway is available.
•
arpTimeout The time in seconds to expire entries in the arp cache. By
default this is set to 30000 (about 8 hours).
•
snmpReadCommunity The SNMP community name to be recognized for
SNMP Get and GetNext requests. By default this is the string “public”.
•
snmpWriteCommunity The SNMP community name to be recognized for
SNMP Set requests. By default this is the string “private”.
•
snmpTrapCommunity The SNMP community name to be used in SNMP
trap messages. By default this is the string “public”.
•
snmpName The value of the SNMP Systems Group SysName variable. This
is usually identical to the host name, for example, “switch001”. The default
value for this parameter is the empty string, “”.
•
snmpContact The value of the SNMP Systems Group SysContact variable.
This is usually set to identify the person or organization responsible for
maintaining the host, for example, “Joe Cable, x1234”. The default value for
this parameter is the empty string, “”.
•
snmpLocation The value of the SNMP Systems Group SysName variable.
This is usually set to identify the physical location of the Switch, for
example, “Wiring Closet B, 3rd floor, East”. The default value for this
parameter is the empty string, “”.
•
snmpDoAuthTrap Whether the Switch SNMP agent should send SNMP
authentication traps. By default, traps are not sent.
•
snmpTrapAddress The IP address of the management station to which
SNMP traps should be sent. By default, this is the local host address,
127.0.0.1.
Summary of Contents for SANbox-8
