B – Command Line Interface
Show Command
59021-05 A
B-43
domains
Displays list of each domain and its worldwide name in the fabric.
donor
Displays list of current donor configuration for all ports.
fabric
Displays list of each domain, fabric ID, worldwide name, node IP address, and
port IP address.
interface
Displays the status of the active network interfaces.
log [option]
Displays log entries. Refer to the
Show Log Command on page B-58
.
lsdb
Displays Link State database information.
mem [count]
Displays information about memory activity for the number of seconds given by
[count]. If you omit [count], the value 1 is used. Displayed memory values are in
1K block units.
ns [option]
Displays name server information for the specified [option]. If you omit [option],
name server information for the local domain ID is displayed. [option] can have the
following values:
all
Displays name server information for all switches and ports.
[domain_id]
Displays name server information for the switch given by [domain_id].
[domain_id] is a switch domain ID.
[port_id]
Displays name server information for the port given by [port_id]. [port_id] is a
port Fibre Channel address.
pagebreak
Displays the current pagebreak setting. The pagebreak setting limits the display of
information to 20 lines (On) or allows the continuous display of information without
a break (Off).
Note:
This keyword will display memory activity updates until [count] is
reached – it cannot be interrupted. Therefore, avoid using large values
for [count].
Summary of Contents for SANbox2-16 Fibre Channel
