10 – Performing Diagnostics
Viewing the Diagnostic Test Results
FS0054603-00 C
10-11
Q
10.4.2
Read/Write Buffer Test Results
The Read/Write Buffer Test Results section provides the following information, as
shown in
figure 10-4
.
Figure 10-4. Diagnostic Test Results—Read/Write Buffer Test
■
Loop ID/Status
❑
The loop ID of the HBA when operating in loop mode.
❑
The status of the test—whether the test passed or failed. The possible values:
❑
Success.
The test passed.
❑
Error.
A data miscompare or link status firmware error occurred.
❑
Failed.
A link status error, SCSI write buffer error, or SCSI read buffer error
occurred.
❑
Unknown.
The target was not present.
❑
Unsupported.
The device does not support this test.
■
Data Miscompare.
The possible values:
❑
0 (no data miscompares)
❑
Device not present
❑
Get link status failed
❑
Read buffer failed
Summary of Contents for SANsurfer FC HBA Manager Application
