![background image](http://html1.mh-extra.com/html/qlogic/silverstorm-9020/silverstorm-9020_quick-start-manual_766453005.webp)
3
Changing the IP Address and Default Gateway
Using the RS232 Serial Port
Step 1. Connect null-modem/crossover serial cables to the RS-232 ports
of the switch. If using a terminal emulation device, the settings should be:
❑
8 data bits
❑
no parity bits
❑
1 stop bit
❑
56K baud
❑
Use VT100 emulation.
❑
Flow control = XON/XOFF
Step 2. Power up the switch.
Step 3. To change the switch default IP address enter:
setChassisIpAddr -h ipaddress -m netMask
where
-h ipaddress
is the new IP address in dotted decimal (i.e., xxx.xxx.xxx.xxx) format, and
-m netMask
is the new subnet mask in dotted decimal (i.e., xxx.xxx.xxx.xxx) format.
Step 4. To change the switch default gateway IP address enter:
setDefaultRoute -h ipaddress
where
-h ipaddress
is the new default gateway IP address in dotted decimal (i.e., xxx.xxx.xxx.xxx) format.
Using Telnet or SSH
Step 1. Power up the switch.
Step 2. Connect a Category 5 or 6 (Cat 5/6) Ethernet cable to the RJ-45
connector on the switch. Connect the other end of the Cat 5/6 to a OOB LAN
workstation.
Step 3. Access the switch with the following command:
telnet 192.168.100.9
Summary of Contents for SilverStorm 9020
Page 10: ...8 ...