QLT 23C14/15000, Instruction Manual

OPERATION METHOD

I. 

Power supply operation

Open battery cover and place the two #7 batteries into the battery compartment of massager 

based on the polarity.
II. 

Functional operation

1) 

Press the power switch of massager to “ON”, wipe the cervical vertebra and conduc-

tive pole piece with wet towel, and place the massager closely to neck. Please clean the sweat 

stain in cervical vertebra before use.

2) 

Press the “On/Off” key on the right hand shank of massager. The working procedure 

is started after hearing “beep” of the buzzer. Then indicator light 1 lights up. Press “Strong” key 

on the left hand shank once again and access into the setting automatic composite massage

mode 1;
A. 

Automatic composite massage mode 1;

B. 

First gear is massage strength;

C. 

Timing: 15 minutes;

Press “On/off” key on the right hand shank to shut down and stop massage. Use of “MODE” key

Mode switch key: six modes can be selected by pressing “MODE” on the right hand shank; the 

default boot setting is mode 1 (automatic composite mode 1) and the mode indicator light 1 lights 

up. Strength will be set as the first gear after every mode switch. The six massage modes are 

shown as below: Mode 1: automatic composite 1; mode indicator light 1 lights up;

Mode 2: automatic composite 2; mode indicator light 2 lights up; Mode 3: manipulation; mode 

indicator light 3 lights up;

Mode 4: shiatsu; mode indicator light 1 and 3 light up at the same time;

Mode 5: malaxation; mode indicator light 2 and 3 light up at the same time; Mode 6: beating; mode 

indicator light 1, 2 and 3 light up at the same time;

Automatic composite mode 1 and 2 are manual modes behind the automatic cycle and will be 

switched automatically every minute. Automatic composite mode is recommended.
Use of 

“STRONG”

 key

Strength increasing key: strength is set as 0-gear at each boot. Press 

“STRONG”

key on the left hand shank once to increase one-gear strength. There are totally 16 gears. 

Please select the acceptable strength for massage. Low gear is recommended for first use.
Use of 

“WEAK”

 key

Strength weakening key: press 

“ WEAK ”

 key on the left hand shank once to reduce one-gear 

strength. There are totally 16 gears. 10-20 minutes is recommended for daily use.