QS series manual v3.09
QMAXZ © 2009
- 26 -
Replacing rotating / glass gobo
1. Disconnect the fixture from mains power and let it to cool down completely.
2. Turn the fixture head horizontally with the top cover on top, and lock the head with the tilt lock.
3. Remove the top cover of the fixture using a Philips head screwdriver to loosen the 4 screws,
the screws are locked for falling out so the can not be taken out completely, lift the cover and
loosen the safety cable on the back side.
4. Lift the rotating gobo-holder a little bit from the wheel and pull it towards you to take it out.
5. Remove the fixation spring from the holder and take out the gobo.
6. Put in a new glass gobo, with the most reflective side towards the lamp.
7. Put back the gobo holder by sliding it into the pressing clamp and then press it towards the
wheel lock into the snaps.
8. Attach the safety cable of the cover again, and put the cover back on, tighten the 4 screws.
9. MAINTENANCE
Unplug from mains before starting any maintenance work and let the
fixture cool down completely.
It is essential to keep the fixture clean from dust, dirt and smoke-fluid residues. Therefore we
recommend cleaning the fans every 15 days, depending on the circumstances.
Remove dust from fans and ventilation inlet with a soft brush, cotton swab, vacuum, or compressed
air. The lens, gobo’s and dichroic colours should also be cleaned monthly to ensure a optimum light
output, but will also allow the fixture to function reliably throughout its life.
A soft lint-free cloth moistened with any good glass cleaning fluid is recommended, under no
circumstances should solvents be used!
The QMAXZ fixture does not require lubrication under normal circumstances. The slides for the zoom
and focus lens cars are lubricated with a long-lasting Teflon-based grease that can be reapplied by
you’re dealer.
Check mains power plug regularly, for connection and mechanical liability.
Summary of Contents for QS Series
