QS series manual v3.09
QMAXZ © 2009
- 4 -
Protection from electric shock
•
Keep the fixture away from rain and moisture.
•
Disconnect the fixture from AC power before removing or installing the lamp, fuses, or any
part, and when not in use.
•
This device falls under protection class I. Therefore always ground (earth) the fixture
electrically.
•
Make sure that the power cord is not damaged. Check the fixture and the power cord from
time to time.
•
Make sure that the available voltage is not higher than stated on the power panel.
•
Make sure that the power-switch is set to OFF-position before you connect the device.
•
Connecting the main power supply should be done by a qualified professional person.
•
Refer for any service operation not described in this manual to a qualified technician.
Protection from UV radiation and lamp explosion
•
Never operate the fixture with missing or damaged lenses and/or covers.
•
When replacing the lamp, allow the fixture to cool for at least 30 minutes before opening the
fixture or removing the lamp. Protect your hands and eyes with gloves and safety glasses.
•
Do not stare directly into the light. Never look at an exposed lamp while it is lit.
•
Replace the lamp if it becomes defective or worn out, or before usage exceeds the maximum
lifetime.
4.
RIGGING
THE
FIXTURE
Fixture base
Mounting Bracket
Attach both of the supplied mounting brackets to the fixture base by placing the brackets on the
fixture base matching the mounting holes and turning the twist locks by 90 degrees clockwise until
they are mounted tightly. Always use both brackets when rigging the fixture.
When hooks or clamps are connected to the brackets for rigging, verify that the hooks or clamps are
undamaged and can bear at least 10 times the weight of the fixture.
To un-mount the brackets turn the twist lock by 90 degrees counter clockwise and release the
brackets from the fixture base.
Summary of Contents for QS Series
