.
.
QMD Install manual D06400210010G PTZ Dome Camera
38
6.4.4
Put Camera Back To Housing
1.
Check the setup of the camera ID, baud rate and protocol are properly done
（
Fig-14
）
(see page 7 for setup information)
Fig-14
2.
Follow the alignment tag given by the sticker on the base, hold the camera
and send it into the
housing all the way to the end. Rotate the camera
clockwise to lock it in position.
(Fig-15
）
Take hands back off camera very slowly to ensure it is fully integrated to the
housing. If the camera moves, shakes or drops down after your hands are off,
hold it quickly, rotate it counter-clockwise to release it from the housing and
re-do the integration.
LO
CK
MA
RK
PU
SH
LO
CK
OP
EN
Fig-15
