$ERXW+DUG
'LVNV
6WRUDJHDQG6FDQQLQJ'HYLFHV
&RQIDUG'LVNV
To configure the hard disk(s) you may need to either Enable Disk
Swap or increase the Disk Cache size, depending on your printer’s
memory. (See the following section that applies to your printer mem-
ory.)
After the Administration/Memory/Enable Disk Swap or Administration/
Memory/Manual Config/K Mem Disk Cache menu settings are recon-
figured and the printer is restarted, you need to print a status page to
check that the Disk Cache size is increased. (Notice that
VM
remaining
memory is also increased.)
$GGLWLRQDO0HPRU\
If your printer has more than 16 MB memory, then you only need to
increase the Disk Cache size to 256 KB. See chapter 4, “Printer Con-
figuration,” of the
Reference manual for more information on increas-
ing the disk cache client’s size.
8VLQJ-D]DQG=LS'ULYHV
Keep the following in mind when using Jaz and Zip drives:
The Disk cache must be increased to 800 KB in order for Jaz and
Zip drives to work.
Data can be backed up only to Jaz and Zip drives, not to external
SCSI hard disks.
Jaz and Zip drive information shows up on the start-up and status
page only if media is present in the drive.
If a Jaz or Zip drive is attached to the printer but no media is
present, you will experience a long delay (30 seconds or more)
when you take the printer off line and put it back on line.
Jaz and Zip drives cannot be used for disk swapping or
accounting. They can be used only for font and file storage and
for data backup and restoration.
Summary of Contents for 2060
