"&
"!$#&!$
*,
@1"
1
Turn the printer off and on again to produce a start-up page.
2
Compare the serial port settings listed on the start-up page to those in your
AUTOEXEC.BAT file.
3
Try the communication test again.
If a blank page ejects from the printer, the printer and the PC are communicating. If a
blank page doesn’t eject and you typed the file correctly, refer to your DOS documen-
tation for more information.
Next (one
or more
times)
Advance to the correct baud rate.
BAUD RATE
#
Select
Select the displayed baud rate.
#
IS SELECTED
SERIAL
BAUD RATE
»
Note:
If you need to change other settings, press the Next key to access the
appropriate menu option, and then return to the point where you press the Select key to
access the Administration menu and select the new settings.
Online/
Offline
Access the Save Changes option.
SAVE CHANGES?
*NO
Next
Advance to the Yes option.
SAVE CHANGES?
YES
Select
Save changes.
IDLE
Online/
Offline
Put the printer back on line (the Ready indicator
lights).
IDLE
Press this
key...
to...
The message window
reads...
Summary of Contents for 3260
