76
4.2.5.2 Target Managem ent
You can create multiple LUNs for an iSCSI target. In this chapter, the following topics
are covered:
C re a ting iSC SI Ta rge ts
Note :
The following information only applies to ARM-based NAS models with
firmware version
3.3.0 or la te r
and x86-based NAS models running firmware
version
3.2.0 or la te r
.
You can create multiple LUNs for an iSCSI target. Follow the steps below to create
more LUNs for an iSCSI target.
1. Click "Quick Configuration Wizard" under "Target Management".
2. Select "iSCSI LUN only" and click "Next".
3. Select the allocation method. Enter the name of the LUN, select the LUN directory,
and specify the capacity for the LUN. Click "Next."
4. Select the target to map the LUN to (optional).
5. Confirm the settings and click "Next."
6. When the LUN has been created, click "Finish" to exit the wizard.
7. The LUNs can be mapped to and unmapped from the iSCSI target anytime. You can
also unmap the LUN from a target and map it to another target.
Ite m
Sta tus
De s c ription
iSCSI target
Ready
The iSCSI target is ready but no
initiator has connected to it yet.
Connected
The iSCSI target has been
connected by an initiator.
Disconnected
The iSCSI target has been
disconnected.
Offline
The iSCSI target has been
deactivated and cannot be
connected by the initiator.
76
77
78
78
