7.
Attach the case cover.
For details, see
8.
Connect all cables and external attachments.
9.
Connect all cables and external attachments.
10.
Power on the NAS.
11.
Verify that the module is recognized by the NAS.
a.
Log on to QTS as administrator.
b.
Go to
Control Panel
>
System
>
System Status
>
Hardware Information
.
c.
Check the value for
Total memory
.
Hot-Swapping Redundant Power Supply Units
Warning
The NAS may have one or more power supply unit (PSU) cords. To avoid serious injuries,
a trained service technician must disconnect all PSU cords before installing or replacing
system components.
1.
Power off the NAS.
2.
Disconnect the power cord from the electrical outlet and the PSU that you are replacing.
3.
Firmly press and hold the latch toward the handle and then pull the PSU out.
• TS-453DU-RP
• TS-853DU-RP, TS-1253DU-RP
TS-x53DU User Guide
Installation and Configuration
32
