QNN SAFE AUSTRALIA PTY LTD
ABN 47 168 078 233
Unit 9 / 376 Newbridge Road, Moorebank NSW 2170
Web site:
www.qnnsafe.com.au
Email:
info@qnnsafe.com.au
Phone: 02-87982669
Page 2 of 3
Fingerprint Registering Instructions:
Press the Setup Button which is located behind the door plate, near the upper hinge,
It lights up the Reading Window.
Place your finger on the Reading Window, until the light is off with one beep.
After on second, the green light is on. Then place your
same
finger on the
Reading Window, until green light is off with two beeps. The fingerprint is now
registered successfully.
Testing the registering before closing door.
If the light goes off with 3 beeps, it means that the registering is failed. After
remove the finger from the Reading Window, the light will goes on again for
registering again.
3 failed tries will end the register process, and it needs to press the Setup Button
again to start a new registering process.
The system can story 250 Registered Fingerprints. Any dirt, sweat, oily on your
registered finger will reduce the change of successful reading. We strongly
recommend that you registered at least two fingerprints into the system at this
time.
Deleting Registered Fingerprints (Restore factory setting)
Cut off the power supply by remove at least one battery from the battery box
Press the button located above the Reading Window at the front panel
Put back the battery while holding down the Setup Button which is located behind
the door plate, near the upper hinge,
Ensure battery power is connected and then release the Setup Button after at least
2 seconds.
With 1 beep, follow by 4 beeps, which is indicate that all the Registered
Fingerprints are removed from the system successfully
Cautions:
At this stage, any person could open the safe with the master key.
Please register your fingerprint immediately to protect the
contents inside the safe.
