Callout
Description
4
Neutral wire colored white
5
Ground wire colored green
6
Terminal screw marked green
3. Check that all the wires are in the correct position.
4. Mount the device with the screws and attach the faceplate.
5. Turn on the mains power at the fuse board or circuit breaker.
Enrolling the device with Auto Learn Enroll
Before you begin:
Ensure power is connected to the device.
1. On the IQ panel menu, select
Settings > Advanced Settings > Enter Installer Code >
Installation > Devices > Automation > Auto Learn Devices.
2. Press and hold both buttons on the device until the LED turns orange for 2 seconds.
3. Release both buttons, and the LED turns off. The device enters enrollment mode, and the panel
is notified of the device initiating enrollment.
4. When the device is recognized, tap
OK
when the pop-up window appears. Enter the device
details in the next configuration pop-up window.
5.
Optional:
Enter the PIN code on the product label for increased security during enrollment. The
device does not pair with the panel if you enter an incorrect PIN code.
6. Tap
Pair
.
7. If the device does not automatically enroll, perform a factory reset as indicated in the
section of the user manual.
Result
: The device enrolls successfully.
3
IQ Smart Socket-PG Installation Guide
D-308964 IQ Smart Socket-PG Install Guide
