Enrolling the device with Add PowerG
Before you begin:
Ensure power is not connected to the device.
You can enroll the device in the IQ panel using the Add PowerG feature or scan the QR code on
the box. To enroll the device in the IQ panel using the Add PowerG feature, complete the following
steps:
1. On the IQ panel menu, select
Settings > Advanced Settings > Enter Installer Code >
Installation > Devices > Automation > Add PowerG.
2. Enter the sensor id in the Sensor ID field or scan the QR code on the box label to enroll the
device.
3.
Optional:
Enter the PIN code on the product label for increased security during enrollment. The
device does not pair with the panel if you enter an incorrect PIN code.
4. Tap
Pair.
5. Plug in and power on the device.
Result:
The device enrolls successfully.
Considerations when you enroll a device
The following considerations apply when you enroll a device with PowerG or when you enroll a
device with Auto Learn enroll.
• If the buttons remain pressed after the light is turned off, the device returns to lowpower mode.
• If the connection is successful, the PowerG signal strength displays on the device.
• If the connection fails, a
Not enrolled
status displays on the control panel.
Checking the PowerG signal strength of the device
1. Ensure that the IQ Outdoor Plug-PG is powered on.
2. On the IQ panel, tap
Settings > Advanced Settings > Enter Installer Code > Installation >
System Tests > PowerG Test > Run
.
PowerG signal strength indication
Table 1: PowerG signal strength
Signal strength
LED colour and pattern
Strong
LED turns green and flashes 3 times
Good
LED turns orange and flashes 3 times
Poor
LED truns red and flashes 3 times
IQ Smart Socket-PG Installation Guide
4
D-308964 IQ Smart Socket-PG Install Guide