LED indication and configuration
Table 2: Device configuration state
#
Configuration
Definition
1
Activation LED enabled
Green LED appears when the load is on. Green LED
does not appear when the load is off.
2
Activation LED disabled
LED is always off.
Note:
The PowerG signal strength test blinking
overrides the Activation LED disabled mode.
Note:
If the connection fails and the LED indicator turns off, reset the device to factory
default. For more information see,
.
Additional behavior of the device
Behavior
Corresponding behavior
Turn the socket on or off using the built-in
button
The IQ Panel updates the status within 10
seconds.
When enrolled
The IQ Panel registers the device as a PowerG
device.
When power is removed from the device
The IQ panel updates the device status to
unreachable within 14 minutes.
When power is restored to the device
The IQ panel automatically updates the device
status to normal within 5 minutes.
When communication is lost and then restored The IQ panel automatically updates the device
status to normal within 5 minutes.
Resetting the device
1. Press and hold both buttons for 2 seconds. The LED turns orange to indicate a long press.
2. Release briefly, then press and hold the button again for 5 seconds until the LED turns red
and flashes 3 times to indicate a reset to factory default.
Note:
- After the reset, the device does not start enrollment automatically. For more
information on device enrollment, see
- After a device is reset back to factory default, you must delete it from the panel and
re-enroll the device.
Troubleshooting
WARNING:
The wiring should only be changed in accordance with applicable electrical codes
and regulations in your region.
WARNING:
Only a qualified professional should attempt to change electrical wiring.
5
IQ Smart Socket-PG Installation Guide
D-308964 IQ Smart Socket-PG Install Guide
