QUICK GUIDE-IQ2
PAIRING THE IQ2 WITH THE IQ PANEL
Perform the following steps on the
IQ Pane
l to pair an IQ2
(Note: The IQ Panel must be on
1.5.1 software or higher and connected to the same Wi-Fi Network as your IQ2)
Touch
“Settings”
Enter installer code
(default is 1111)
Touch
“Installation”
Touch
“Add New”
Touch “Quick Name” to open a
selection of default name choices*
*Or create a custom name by touching
the “Device Name” box)
To get the IP Address from your IQ2:
The IQ2 will take a moment to synchronize with the IQ Panel over the network.
Once complete it will display the home screen. To add additional IQ2 tablets
repeat steps above with up to three (3) total devices.
Touch “IQ2
Devices”
Touch
“Security
Account”
Scroll to the bottom of the page and make
sure the box next to “IQ2 Panel” is checked.
Enter the IP Address
of the IQ2* into the
appropriate field on
the IQ Panel then
touch “Save”
* * * *
Touch “Back”
twice to get to
the Settings page
Page of Qolsys Confidential and Proprietary.
2
2
Touch
“Settings”
Touch
“About”
Locate “IP
Address”
NEED HELP? (855) 4-QOLSYS TECHSUPPORT@QOLSYS.COM
CONNECTING THE IQ2 TO WI-FI
Touch
“WiFi
Settings”
Touch “WiFi
Settings”
The IQ2 pairs with the IQ Panel over a secure Wi-Fi Network (802.11 B, G, N) and must be connected to the
same network as the IQ Panel before you can add it to the system. To connect to a secure Wi-Fi:
IMPORTANT: Please check that the IQ2 can successfully connect to the network in the chosen installation location
Select network from
available list.
Enter Wi-Fi network
password.
Make sure Wi-Fi
is turned on
(swipe right)
Touch
“Settings”
Type in
Master Code
(default is 1234)
* * * *
POWER UP THE DEVICE
Press and hold the power button until the screen illuminates (approx 3-5 sec)
