Carefully close the cover
Turn the power ON and wait 5
seconds until the printer is
initialized
Press and hold the button
until you hear one beep
The printer will start
automatic label identification
MAINTANCE
Printer head cleaning steps:
1.
Turn the printer off, remove the power cord and open the cover
2.
Wait until the printer head cools down. The printer head can be very hot after printing.
3.
Completely clean printer head using swab with an alcohol solvent (ethanol or
isopropanol) - do not use water!
4.
Wait until the alcohol has completely vaporized, then close the cover.
5.
Connect the power cord and print a test page to check if it is clean.
NOTICE
Ensure power is off when performing maintenance
Do not touch or scratch the printer head surface, roller or sensors
Avoid gas, acetone or other organic solvents
Wait until alcohol has completely vaporized before you close the cover