9
In the step 2, the connection between the S-video and C-Video output
signals to the projector was established, where the RGB cable runs from
the visualizer and goes to the projector. Once the connections have been
made as detailed in the steps 2, 3, 4, input signals from the computer
、
visualizer CCD, C-Video and S-Video are going to the RGB1 input on the
projector and will be displayed on the projector screen as RGB1. These
signals can be seen in turn when pressing “CCD/PC1/PC2” and
“S-VIDEO/VIDEO” on the control panel of the visualizer.
Step 5: Connect to the second video equipment with video input.
Step 6: Connections for external control from the computer.
Use the computer RS232 cable (9-pin to 9-pin) to make the
RS 232 connector
USB connector
of the computer
of the computer
USB cable
RS-232 cable
Side Panel
USB
PROJECTOR MIC
RGB IN
AUDIO IN
RS232
Video in
Projector Color monitor
S-VIDEO
AUDIO
OUT
OUT
AUDIO
VIDEO
S-VIDEO
VIDEO
IN
IN
AUDIO
Rear Panel
AUDIO IN
PROJECTOR
OUT -COMPUTER- IN
OUT-12V- IN
Video equipment
Audio out
Video Cable
Video out
