Sign-in-China.com
Online Wholesale for AD & Signage Products
Learn More >>
- 21 -
adjustment for bolts on both side.
NOTES: Measure the length for two springs and keep the same height.
3) When the image is tilted on right side, the left side pressure must be smaller than right
side. Adjust the bolts to increase the pressure.
NOTES: Check the spring changes when put max pressure on the machine after
adjustment. If no change, it will cause the spring damage during laminating. If no extra
space to adjust on left side spring, please try to adjust on right side.
4) After adjustment, fasten the nuts.
5) Put on the left side cover.
Adjustment principle: if the image is off-tracking to the left side, the pressure of the
left side is higher than the right side. Loosen the spring on the left side to reduce its
deflection.
ROLLER PARALLELISM ADJUSTMENT
The gap is 1-2mm between bottom and top roller, if the gap isn’t the same, take a record
for the smaller gap side. Make the hand wheel feel loose, turn off the machine, open the
left(right) side cover. Loosen the nuts, adjust the location of the bolts until the roller is
parallel. At last, put on the left side cover.
NOTE: The roller is parallel before shipment. The roller parallel can’t be changed.
Pressure should be adjusted first when have the tilted problem. Only adjust the bolt
when the roller isn’t parallel. Roller pressure should be adjusted accordingly after
change the bolt.
Tools:
5mm inner hexagon spanner, 8mm wrench.
