QPE6105A
FCC Certification Guide
– Bluetooth™ Low Energy Mode
Subject to change without notice | All rights reserved. © 2022-2023 Qorvo, Inc.
GP335_UM_20021 Version 1.00
Page
7
of
15
®
4
Operating Manual
4.1
System Setup
Test software allowing control of the radio is distributed via Radio Control Software packages [1] [2]. These
packages consist of a Radio Control Console (RCC) PC application and Product Test Component (PTC)
firmware binaries. Below figure shows the high-level overview of the system.
Figure 3: System Setup
The physical interface in-between the RCC application and the PTC firmware is a UART link. The UART pin
mapping options are described in the PTC release notes.
The PTC firmware [2] should be flashed into the processor of the DUT. The RCC application can be started
by means of the RadioConsoleControl.exe executable.
Figure 4: QPE6105A Module on Radio Adaptor Board
